Well, this has gotten messy. Now that I've set the debugger, Panda just stops at 2% instead of showing an error or claiming to be finished. (It doesn't FREEZE, but the 'scanned' number stops increasing, and my hard drive stops making noise.)
However, now it seems like there's a 25% chance that the scan will actually complete normally? And I've noticed a pattern:
When it stops progressing, it says 2% complete, and approximately 7,620 files scanned.
But when it completes normally, it can be at over 50,000 files scanned and still say "1%".
Actually, I've taken a few screenshots of it in the "stopping at 2%" state, and it seems like it's always in the same folder:
http://imgur.com/a/nQNVa
Also, I'm pretty sure that once it's managed to complete a scan successfully, it won't stall again until after the next reboot.
(Also, just a tip about your instructions -- my 'Windows Kits' folder was in 'Program Files (x86)', not 'Program Files', so someone following your instructions to the letter on a 64-bit system might have trouble.)
[CLOSED] "Unexpected error. Error code 1."
-
- Registered user
- Posts: 6
- Joined: Sun, 16 Oct 2016, 18:52
- VirusBuster
- Official moderator
- Posts: 7595
- Joined: Mon, 02 Apr 2012, 18:53
- Location: Panda HQ - Bilbao
Re: "Unexpected error. Error code 1."
It seems that its being stuck at Internet Explorer's temporary files
Open Internet Explorer and go to Tools - Internet options - Delete...
You can also delete the content of the following folder as:
C:\Windows\System32\config\systemprofile\AppData\Local\Microsoft\Windows\Temporary Internet Files\Content.IE5
Open Internet Explorer and go to Tools - Internet options - Delete...
You can also delete the content of the following folder as:
C:\Windows\System32\config\systemprofile\AppData\Local\Microsoft\Windows\Temporary Internet Files\Content.IE5
Regards,
Jorge Torre
TechSupport Department - Panda Security
I don't reply to private messages unless I have previously requested them
Jorge Torre
TechSupport Department - Panda Security
I don't reply to private messages unless I have previously requested them
- VirusBuster
- Official moderator
- Posts: 7595
- Joined: Mon, 02 Apr 2012, 18:53
- Location: Panda HQ - Bilbao
Re: "Unexpected error. Error code 1."
Closed due to lack of response
TOPIC CLOSED
TOPIC CLOSED
Regards,
Jorge Torre
TechSupport Department - Panda Security
I don't reply to private messages unless I have previously requested them
Jorge Torre
TechSupport Department - Panda Security
I don't reply to private messages unless I have previously requested them